Instructions / Assembly

1 Install a left roof panel 10511 at
the left rear corner of the roof.
3 Install two roof panels 6538 work-
ing side to side. Fold the lower sec-
tion of the roof panels down. Cover
the notches with the strips of weather
stripping tape. Save the rest. Do not
fasten the lower end of the panels to
the side wall angles at this time. Con-
tinue weather stripping the ridge open-
ing.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible
28
Step 15
WP28
●●
●●
● 10511 Left Roof Panel (1)
●●
●●
● 6538 Roof Panel (2)
●●
●●
● 6869 Ridge Cap (3)
● Parts Needed For ●
Ridge Caps & Panels
2 Cut 28 short 3"(7,6cm) strips off the
small roll of weather stripping tape,
and put them aside. Cover the joint at
the peak with weather stripping tape,
large roll. Unroll the tape and press it
down over the opening at the ridge as
you install each roof panel. Do not cut
the tape at this time.
4 Install three ridge caps 6869 on
the completed roof section using bolts
and nuts. Do not fasten the ends of
the ridge caps at this time.
5 Fasten the roof panel ribs, peak
caps and ridge caps together using
bolts and nuts.
Screws To
Roof Beam
Fasten At
Overlap With
Bolt
Fasten at
Overlap With
Bolt
Screws To
Roof Beam
Do not fasten
at this time
STEP
3
Weather Stripping Tape
STEP
5
STEP
2
STEP
4
STEP
1
6538
STEP
3
Strips
6538
6869
10511
6869
6869
FRONT
Roll