Instructions / Assembly

Step 2
SX15
15
● Parts Needed For ●
Frame Assemblies
The main frame pieces reinforce the
walls. This piece will later be installed
at the top edge of the side walls and
the rear wall. Proceed as follows:
1 Overlap the rear wall angle pieces
as shown in the figure and fasten
them together with one bolt in the
single, large hole.
2 Make two side wall angles by
overlapping the side wall angle
pieces as shown. Fasten each set
together with two bolts thru the sec-
ond set of large holes from each end.
3 Set the assemblies aside. You will
use them later.
●●
●●
● 10396 Rear Wall Angle (2)
●●
●●
● 10395 Side Wall Angle (4)
STEP
1
10396
10396
Side Wall Angles
140 3/8" 3,6m
3 3/4"
9,5cm
Rear Wall Angle
118 1/8" 3m
4 1/2"
11,4cm
10395
10395
STEP
2
4 1/2"
11,4cm
3 3/4"
9,5cm