Instructions / Assembly

Each screw in the wall requires a
washer.
1 Slide side siding into channels of
corner and splice posts, flat edge
upward, bottom edge down resting
on floor frame. Always follow this
pattern. Fasten bottom edge and tab
of stud to floor frame using screws.
Fasten center to stud with screws.
Do not fasten top edge yet.
2 Install side siding as before. Note
how the slot in bottom edge must
overlap flat edge of last siding. Fas-
ten both siding panels to stud at this
overlap.
3 Install side siding to the top as
before.
4 From inside building, fasten siding
to corner posts and splice post using
screws.
5 Repeat steps 1 through 4 opposite
side of building.
NOTE
Be careful to install the correct
panel in each position as shown.
The floor frame must be square
and level or holes will not align.
●●
●●
● 6287 Side Siding (12)
● Parts Needed For ●
Side Siding
Step 11
SX24
24
STEP
5
STEP
4
STEP
STEP
3
STEP
2
1
Bottom
Edge
FRONT
Flat
Edge
Be certain all siding
overlaps are fastened
with a single screw
6287
End
View
Washer
THIS SCREW MUST
FASTEN TAB OF STUD
6287
6287