Instructions / Assembly

1 Install a left roof panel 6641 at the
left rear corner of the roof.
2 Cover the joint at the peak with
weather stripping tape. Unroll the
tape and press it down over the open-
ing at the ridge as you install each
roof panel. Do not cut the tape at this
time.
3 Install two roof panels 6529 work-
ing side to side. Do not fasten the
lower end of the panels to the side
wall angles at this time. Continue
weather stripping the ridge opening.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible
4 Install the first ridge cap 6869 on
the completed roof section using bolts
and nuts. Do not fasten the ends of
the ridge cap at this time.
5 Fasten the roof panel ribs, peak
cap and ridge cap together using
bolts and nuts.
●●
●●
● 6641 Left Roof Panel (1)
●●
●●
● 6529 Roof Panel (2)
●●
●●
● 6869 Ridge Cap (1)
Step 17
SX30
● Parts Needed For ●
Ridge Cap & Panels
STEP
1
Screws To
Roof Beam
Screws To
Roof Beam
STEP
4
Weather
Stripping
Tape
30
Do not fasten
at this time
6529
Roof
Panel
STEP
2
STEP
5
STEP
3
6529
6641 Left
Roof Panel
6869
Fasten At
Overlap
With Bolt
Fasten At
Overlap
With Bolt
NOTE
If roof beam holes do not line up with
the roof panel holes, shift the building
from left to right. If this does not help,
your building may not be level. Shim
the corners until holes line up.