Installation Guide

Each screw and bolt in the wall
requires a washer.
1 Slide side siding into channels
of corner and splice posts,  at edge
upward, bottom edge down resting
on  oor frame. Always follow this
pattern. Fasten bottom edge and tab
of stud to  oor frame using screws.
Fasten center to stud with screws.
Do not fasten top edge yet.
2 Install side siding as before.
Note how the slot in bottom edge
must overlap  at edge of last siding.
Fasten both siding panels to stud at
this overlap.
3 Install side siding to the top as
before.
4 From inside building, fasten siding
to corner posts and splice post using
screws.
5 Repeat steps 1 through 4 opposite
side of building.
NOTE
Be careful to install the correct
panel in each position as shown.
The  oor frame must be square
and level or holes will not align.
 6287 Side Siding (12)
 Parts Needed For 
Side Siding
Step 11
SX24 ctr
STEP
5
STEP
4
STEP
STEP
3
STEP
2
1
Bottom
Edge
FRONT
Flat
Edge
Be certain all siding
overlaps are fastened
with a single screw
6287
End
View
Washer
THIS SCREW MUST
FASTEN TAB OF STUD
6287
6287
(48)
(56)
CORRECT
INCORRECT
24