Installation Guide

Each screw in the wall requires a
washer.
1 Slide side siding into channels
of corner posts, flat edge upward,
bottom edge down resting on  oor
frame. Always follow this pattern.
Fasten bottom edge and tab of stud
to  oor frame using screws. Fasten
center to stud with screws. Do not
fasten  at edge yet.
2 Install side siding as before.
Note how the slot in bottom edge
must overlap  at edge of last siding.
Fasten both siding panels to stud at
this overlap.
3 Install side siding to the top as
before.
4 From inside building, fasten sid-
ing to corner posts using screws.
5 Repeat steps 1 through 4 for op-
posite side of building.
NOTE
Be careful to install the correct
panel in each position as shown.
The  oor frame must be square
and level or holes will not align.
 8719 Side Siding (6)
 Parts Needed For 
Side Siding
Step 9
X22
THIS SCREW MUST
FASTEN TAB OF STUD
STEP
2
STEP
3
Be certain all Siding
overlaps are fastened
with a single screw
Washer
8719
8719
End
View
Flat
Edge
Bottom
Edge
FRONT
STEP
1
STEP
4
22
CORRECT
INCORRECT