Installation Guide

Step 14
X27et
 Parts Needed For 
Right Roof Panel
 8468 Right Roof Panel (1)
27
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner
of the building. Each screw and bolt
in the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square.
This will make the roof panels  t
better, and holes will align.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1 Locate the roof panels by their
numbers. Note the sequence and
position they are to be installed.
2 Position a right roof panel at the
back right corner and fasten to the
top roof beam using a screw.
3 Remove edge trim from the left
gable under the roof panel.
4 Continue fastening the right roof
panel to the gable and lower roof
beam using screws, bolts and nuts as
shown. Do not fasten the lower end
of the panels to the side wall angles
at this time.
8468 Right Roof Panel
FRONT
Washer
Bolt
Gable
STEP
2
STEP
1
Nut
2
3
4
5
6
1
7
FRONT
Hint: Follow the fastener sequence
shown for proper alignment.
STEP
3
STEP
4
8469
8
6
2
4
1
5
7
3
8469
6529
6529
8468
8468
6529 6529