Installation Guide

1 Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
2 Cut 4 short 2" (5,1cm) strips o
the roll of weather stripping tape,
and put them aside. Cover the joint at
the peak with weather stripping tape.
Unroll the tape and press it down over
the opening at the ridge as you install
each roof panel. Do not cut the tape
at this time.
3 Install 2 narrow and 2 wide roof
panels in the sequence and positions
shown on previous page. Do not fas-
ten the lower end of the panels to the
side wall angles at this time. Continue
weather stripping the ridge opening.
4 Install the  rst ridge cap on the
completed roof section using bolts
and nuts. Fasten roof panel over-
laps not used for ridge cap. Cover
the head of bolt with the 2" (5,1cm)
piece of weather stripping tape. Do
not fasten the ends of the ridge cap
at this time.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
Step 15
Y28 ctr
 Parts Needed For 
Roof Assembly
 8468 Right Roof Panel (1)
 8469 Left Roof Panel (2)
 7483 Roof Panel (2)
 6529 Roof Panel (2)
 8840 Ridge Cap (1)
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
Do not fasten
at this time
FRONT
Fasten At
Overlap with
Bolt
6529 Roof Panel
Fasten At
Overlap with
Bolt
Screws To Roof Beam
Weather Stripping
Tape Roll
8469 Left Roof Panel
STEP
2
STEP
8840
STEP
Screws To
Roof Beam
6529 Roof Panel
1
3
STEP
4
7483 Roof Panel
7483 Roof Panel
8468 Right
Roof Panel
(38)
(23)
28