Installation Guide

1 Install the second ridge cap
overlapping the  rst ridge cap while
installing the remaining roof panels.
Continue weather stripping the ridge.
2 Fasten the lower end of the panels
to the side wall angles using screws
and washers. Use bolts and nuts
through wall angle overlaps at the
bottom of the panel.
 8486 Ridge Cap (1)
 7483 Roof Panel (2)
 8485 Left Side Roof Trim (2)
 8836 Right Side Roof Trim (2)
 Parts Needed For 
Panels/Ridge Cap/Trim
Step 16
Y29 ctr
STEP
1
STEP
2
Tuck Flange
Inward to Fit
Inside of
Roof Trim Cap
8486
Roof Trim
Peak Cap
3
STEP
STEP
5
8836
6
3 Attach the right and left side
roof trim to the lower end of the roof
panels on each side of the building
using screws at each panel overlap.
NOTE
A single screw fastens both trim
pieces at the overlap.
4 Using your thumb and index  nger,
overbend the bottom  ange of the
side roof trim at the corner inward
enough so the right and left roof trim
caps  t onto right and left corners.
5 Fasten the roof trim caps to the
side trim using a screw.
6 Fasten the roof panel rib, peak
cap and ridge cap together using
bolts and nuts. Fasten the remain-
ing peak cap in the same manner.
8836
STEP
4
STEP
Cut Weather Stripping
Tape and Fold Under
7483
8485
Roof Trim Cap
8485
7483
(4)
(48)
(16)
29