Specifications

(23) Working inside the vehicle, install the shifter
on the transmission
(24) Install the shifter boot seal.
(25) Install the center console. Refer to Group 23,
Body for the procedure.
(26) Position, connect and secure all engine wiring
in its original position
(27) On L. H. D. vehicles, connect the heater core
coolant supply and brake vacuum supply hoses on
the engine.
(28) On R. H. D. vehicles, position the steel line
assembly and connect the heater core coolant supply
and the brake vacuum supply hoses on the engine.
(29) Install the coolant reservoir supply hose on
the engine (Fig. 24).
(30) Install the innercooler inlet and outlet hoses
on the engine (Fig. 24).
(31) Install the upper and lower radiator hoses on
the engine.
(32) Fill the cooling system. Refer to Group 7,
Cooling System, for the procedure.
(33) Connect the oil pressure sensor electrical con-
nector (Fig. 24).
(34) Connect the EGR vacuum supply hose on the
engine (Fig. 24).
(35) Install the air filter outlet hose and connect
the breather hose on the engine (Fig. 24).
(36) Install the refrigerant suction and discharge
lines. Torque the retaining bolts on the A/C compres-
sor to 22 N·m (200 in. lbs.). Make sure the O-Rings
are well lubricated and free of tears.
(37) Charge the refrigerant system. Refer to Group
24, Heating and Air Conditioning for the procedure.
(38) Install the manual cooling fan.
Fig. 21 Clutch Slave Cylinder
1 – CLUTCH SLAVE CYLINDER
2 – CLUTCH SLAVE CYLINDER RETAINING NUTS
3 – FRONT DRIVESHAFT
Fig. 22 Exhaust System Inlet Pipe Connection
1 – OIL PAN
2 – EXHAUST INLET PIPE FLANGE RETAINING BOLTS
3 – EXHAUST SYSTEM SUPPORT CLAMP
Fig. 23 Engine Ground Wire Location
1 – RIGHT ENGINE MOUNT THROUGHBOLT NUT
2 – ENGINE GROUND WIRE
3 – OIL PAN
XJ ENGINE 9 - 21
REMOVAL AND INSTALLATION (Continued)