Specifications

(31) Install the wire harness mounting bracket
and retaining nuts on the left engine mount. Torque
the nuts to 25 N·m (221 in. lbs.).
(32) Connect the fuel supply and return hoses on
the engine assembly.
(33) Connect the speed control servo vacuum sup-
ply hose on the engine mounted steel vacuum source
line.
(34) Install the battery feed wire on the top of the
generator and install the cover.
(35) Connect the generator field wire connector on
the rear of the generator.
(36) Install the vacuum supply hose on the engine
mounted steel vacuum source line.
NOTE: When lubricating sealing o-rings or gaskets.
Use only the same lubricate that is present in that
system.
(37) Install the power steering fluid pressure line
on the pump (Fig. 30). Be certain the sealing 0-ring
is well lubricated and free of tears.
(38) Install the power steering fluid supply hose on
the pump (Fig. 30).
(39) Install both of the refrigerant lines on the A/C
compressor. Torque the retaining bolts to 28 N·m (21
ft. lbs.). Be certain the sealing gaskets are well lubri-
cated and free of tears.
(40) Install the refrigerant line support bracket
and bolt on the cylinder head cover.
(41) Install the tiestraps retaining the wire har-
ness on the low side refrigerant line.
(42) Install the refrigerant liquid line. Torque the
retaining nut on the bulkhead to 28 N·m (21 ft. lbs.).
Be certain the sealing gasket is well lubricated and
free of tears.
(43) Connect the engine ground. Located just
behind the oil filter.
(44) Connect the oil pressure and boost pressure
sensor electrical connectors and clip the wire harness
on the coolant supply tubes.
(45) Install the low side refrigerant line on the A/C
accumulator assembly. Torque the nut to 28 N·m (21
ft. lbs.). Be certain the sealing gasket is well lubri-
cated and free of tears.
(46) Install the heater core coolant supply hoses on
the engine (Fig. 31).
(47) Install the EGR valve vacuum supply line on
the valve (Fig. 31).
(48) Install the coolant recovery hose on the water
manifold.
(49) Install the coolant reservoir supply hose on
the engine.
(50) Install the cooling module assembly and
retaining bolts (Fig. 32). Torque the bolts to 41 N·m
(30 ft. lbs.).
(51) Install the fan shroud and both cooling fans
as an assembly on the vehicle.
(52) Install the suction and discharge refrigerant
lines on the condenser assembly (Fig. 32). Torque the
retaining nuts to 28 N·m (21 ft. lbs.). Be certain the
sealing gaskets are well lubricated and free of tears.
(53) Position the power steering cooler and install
the retaining bolts (Fig. 32).
(54) Charge the refrigerant system. Refer to Group
24, Heating and Air Conditioning for the procedure.
Fig. 30 Power Steering Fluid Lines At Pump
Fig. 31 Engine Compartment View - Rightside
9 - 22 ENGINE WJ
REMOVAL AND INSTALLATION (Continued)