Specifications

(55) Connect the electric radiator cooling fan elec-
trical connector.
(56) Install the intake air duct on the vehicle (Fig.
32).
(57) Install the upper radiator hose on the vehicle.
(58) Install the radiator overflow hose on the radi-
ator
(59) Connect the breather hose and install the
fresh air inlet tube on the engine.
(60) Install the intercooler inlet and outlet hoses
on the engine (Fig. 34).
(61) Install the manual cooling fan on the engine.
(62) Install the radiator crossmember on the vehi-
cle. Refer to Group 23, Body for the procedure.
(63) Install the upper fan shroud retaining bolts.
Torque the bolts to 15 N·m (132 in. lbs.).
(64) Install the hood latch support brackets and
the hood latch on the vehicle.
(65) Install the headlamp module mounting
(HMM) assembly. Refer to Group 23, Body for the
procedure.
(66) Connect the right and left headlamp module
wire harnesses at the 10-way connectors. Located
just above the front bumper to the right and left of
the a/c condenser.
(67) Connect the ambient temperature sensor and
clip the wire harness on the headlamp module
mounting assembly.
(68) Install the front fascia. Refer to Group 13,
Frame and Bumpers for the procedure.
(69) Install the right and left headlamp assemblies
on the vehicle. Refer to Group 8L, Lamps for the pro-
cedure.
(70) Raise the vehicle on the hoist.
(71) Connect the engine ground. Located to the
rear of the left engine mount.
(72) Install the starter motor. Torque the retaining
bolts to 24 N·m (212 in. lbs.).
(73) Connect the starter motor electrical. Torque
the B+ nut to 15 N·m (132 in. lbs.).
(74) Install the lower fan shroud retaining bolts
(Fig. 35). Torque the bolts to 15 N·m (132 in. lbs.).
Fig. 32 Cooling Module Assembly
Fig. 33 Air Intake Hoses
Fig. 34 Intercooler Hoses
WJ ENGINE 9 - 23
REMOVAL AND INSTALLATION (Continued)