Specifications

(8) Install the intake manifold elbow inlet hose
(Fig. 49).
(9) Raise the vehicle on the hoist.
(10) Install the left engine mount throughbolt nut.
Torque the nut to 61 N·m (45 ft. lbs.).
(11) Install the low pressure refrigerant line and
retaining bolt. Torque the bolt to 28 N·m (21 ft. lbs.).
Be certain the sealing o-ring is well lubricated and
free of tears.
(12) Install the front splash shield.
(13) Lower the vehicle on the hoist.
(14) Connect the negative battery cable.
(15) Evacuate and charge the refrigerant system.
Refer to Group 24, Heater and Air Conditioning for
the procedure.
(16) Start the engine and check for leaks.
WARNING: USE EXTREME CAUTION WHEN THE
ENGINE IS OPERATING. DO NOT STAND IN DIRECT
LINE WITH THE FAN. DO NOT PUT HANDS NEAR
THE PULLEYS, BELTS OR FAN. DO NOT WEAR
LOOSE CLOTHING.
HYDRAULIC TAPPETS
REMOVAL
(1) Disconnect the negative battery cable.
(2) Discharge the air conditioning system. Refer to
Group 24, Heating and Air Conditioning for proce-
dure.
(3) Remove the A/C lines at the compressor and
cap.
(4) Remove the A/C line bracket attached to the
cylinder head cover and move the lines away from
the cylinder head.
Fig. 48 Cylinder Head Cover
Fig. 49 Intake Manifold Elbow
Fig. 50 Tappet And Rocker Arm Assembly
WJ ENGINE 9 - 29
REMOVAL AND INSTALLATION (Continued)