Specifications

(14) Remove the exhaust manifold/turbocharger
heat shield (Fig. 57).
(15) Disconnect the oil feed line from turbocharger.
(16) Disconnect the oil return line from turbo-
charger (Fig. 58).
(17) Raise vehicle on hoist.
(18) Disconnect the exhaust pipe at the turbo-
charger.
(19) Remove the Exhaust manifold and turbo-
charger. Refer to Group 11, Exhaust System and Tur-
bocharger.
(20) Disconnect the boost pressure sensor electrical
connector.
(21) Remove the Intake manifold. Refer to intake
manifold removal and installation procedure in this
section.
(22) Remove the oil feed line support bracket at
rear of the cylinder head (Fig. 59).
(23) Remove the oil feed line for rocker arm
assemblies (Fig. 60).
(24) Remove the Crankcase breather hose from
front of the valve cover
(25) Remove the injector sensor wire and the glow
plug hot lead .
(26) Remove the fuel injector supply lines from
injectors.
(27) Remove the fuel injectors with tool VM.1012
(Fig. 61). Refer to Group 14, Fuel System for proce-
dure.
(28) Remove the cylinder head cover. Refer to cyl-
inder head cover removal and installation procedure
in this section.
Fig. 56 Heater Hoses
Fig. 57 Exhaust Manifold/Turbocharger Heat Shield
Fig. 58 Oil Return Line
WJ ENGINE 9 - 33
REMOVAL AND INSTALLATION (Continued)