Specifications

(29) Remove the rocker retaining nuts (Fig. 63)
(Fig. 64).
(30) Remove the rocker arm assemblies. Place
them on a bench in the same order as removed.
(31) Remove the push rods and place them on a
bench in the same order as removed.
(32) Mark the cylinder head positions.
(33) Remove the engine cylinder head bolts with
special tool VM.1018 and VM.1019.
(34) Remove the engine cylinder head and gasket .
(35) Stuff clean lint free shop towels into the cyl-
inder bores.
CYLINDER HEAD GASKETS
A one piece steel cylinder head gasket is used for
all five cylinder heads.
Cylinder head gaskets are available in three thick-
nesses. Identification holes or notches in the right
front corner of the gasket indicate the thickness of
the gasket (Fig. 65).
Fig. 59 Cylinder Head Oil Supply Line Retaining Clip
Fig. 60 Rocker Arm Oil Feed Lines
Fig. 61 Fuel Injector Tool VM.1012
Fig. 62 Fuel Injector
9 - 34 ENGINE WJ
REMOVAL AND INSTALLATION (Continued)