Specifications

(7) Remove the idler pulley and bracket (Fig. 77).
(8) Remove the automatic belt tensioner (Fig. 77).
(9) Remove the Power steering pump pulley (Fig.
77).
(10) Remove the timing gear cover.
INSTALLATION
(1) Be sure the mating surfaces of the gear case
cover and the cylinder block are clean and free from
burrs.
(2) Apply a continuous 3 mm bead of Silicone
Sealer (Fig. 78) to timing cover, install within 10
minutes, tighten 6mm bolts to 11 N·m (8 ft. lbs.) and
tighten 8mm bolts to 26.2 N·m (19 ft. lbs.).
(3) Install Power steering pump pulley. Torque
bolts to 25 N·m (18 ft. lbs.).
(4) Install the automatic belt tensioner.
(5) Install the idler pulley bracket. Torque bolts to
47 N·m (34 ft. lbs.).
NOTE: The idler pulley has left hand thread.
(6) Install the idler pulleys. Torque nut to 47 N·m
(34 ft. lbs.).
(7) Install the fan pulley. Torque bolts to 28 N·m
(21 ft. lbs.).
(8) Install the vibration damper. Torque nut to 196
N·m (147 ft. lbs.).
(9) Install the accessary drive belt. Refer to Group
7, Cooling System for procedure.
(10) Install the fan and fan shroud.
(11) Connect the negative battery cable.
Fig. 76 VM.1000–A
Fig. 77 Idler Pulley And Tensioner Location
9 - 40 ENGINE WJ
REMOVAL AND INSTALLATION (Continued)