Specifications

(4) Remove shims from cylinder liner or cylinder
block recess. Keep shims with each cylinder liner.
INSTALLATION
(1) Carefully clean residual LOCTITE from liner
and crankcase, and degrease the crankcase where it
comes into contact with the liners. Install the liners
in the crankcase as shown (A), rotating them back
and forth by 45° in order to guarantee correct posi-
tioning (Fig. 106).
(2) Measure the liner recess relative to block deck
with a dial indicator mounted on a special tool
VM-1010 A. All the measurements must be taken
on camshaft side . Zero dial gauge on block deck.
(3) Move dial gauge to cylinder liner record read-
ing on dial gauge.
(4) Remove liner and special tool.
(5) Then select the correct shim thickness to give
proper protrusion (0.01 - 0.06 mm).
(6) Fit the shim and the O-rings onto the liner.
(7) Lubricate the lower liner location in the block.
Apply LOCTITE AVX to the corner of the liner seat.
Apply LOCTITE AVX uniformly to the upper part of
the liner at area.
Fig. 106 Liner Installation
Fig. 105 Liner Inspection
9 - 50 ENGINE WJ
REMOVAL AND INSTALLATION (Continued)