Specifications

4-2 OPERATION CHAPTER 4
DT-203X, DT-105X and DT-110X display series
4.3.1. Modify parameters
To go into modify parameters menu, you should push the advance pushbutton for more
than three seconds, labelled with «*». After the 3 seconds, the display shows the first parameter
in flashing mode.
From this point, there are two options:
1- Display the parameters value.
By pushing advance (“*”) you may see the parameters value. The increase pushbutton,
labelled «+», lets you modify the parameter.
To select the parameters name push the advance pushbutton («*»).
2- Select another parameter.
While the parameter name is flashing, every time you push the increase pushbutton
(«+») you select a new parameter.
4.3.2. Exit modify parameters
To exit the modify parameters menu, select the parameter «END» and then push
advance «*».
4.3.3. Meaning of each parameter.
4.3.3.1. Parameter 1: Language.
The language menu. There are four languages available: Catalan, Spanish, French
and English.
4.3.3.2. Parameter 2: Address
The network display address. Selectable between 0 and 299. Depends on each
protocol.
4.3.3.3. Parameter 3: Protocol
The selected protocol. The protocols available are TDL, Modbus, Omron, ASCII and
S7-200.
4.3.3.4. Parameter 4: Baud Rate
Selects the transmission baud rate. There are two baud rates available: 9600 and
19200.
4.3.3.5. Parameter 5: Data length
Selects the transmission data length. Select 7 o 8 bits.
4.3.3.6. Parameter 6:Parity
Selects the transmission parity. Select Even, Odd or None.