Installation Guide

Step 13
ZS26
 Parts Needed For 
Right Roof Panel
 9798 Right Roof Panel (1)
9798
Right Roof Panel
Washer
Bolt
(7)
Gable
STEP
1
Nut
2
3
4
5
6
7
8
FRONT
9
7
5
1
3
6
8
2
10
4
9797
7954
7861
7954
9798
9797
9798
7954
7861
7954
9
10
1
FRONT
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner
of the building. Each screw and bolt
in the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels fi t better, and holes will
align. Don't anchor the fl oor frame.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to at-
taching the roof panels.
1 Locate the roof panels and fi nd the
right roof panel part number 9798.
2 Position a right roof panel at the
back right corner and fasten to the
top roof beam using screws.
3 Remove edge trim from the left
gable under the roof panel.
Hint: Follow the fastener sequence
shown for proper alignment.
4 Continue fastening the
right roof panel to the gable
and lower roof beams using
screws, bolts and nuts as
shown. Do not fasten the
lower end of the panels to the
side wall angles at this time.
STEP
2
STEP
3
STEP
4
26