Installation Guide

1 Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the front
left corner of the roof.
2 Cut 28 short 3" (7,6 cm) strips off
the roll of weather stripping tape,
and put them aside. Cover the joint
at the peak with weather stripping
tape. Unroll the tape and press it
down over the opening at the ridge
as you install each roof panel. Do
not cut the tape at this time.
3 Install two narrow and two wide
roof panels in the sequence and
positions shown on previous page.
Fold the lower section of the roof
panels down. Cover the notches
with the strips of weather stripping
tape. Save the rest. Do not fasten the
lower end of the panels to the side
wall angles at this time. Continue
weather stripping the ridge opening.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
 9798 Right Roof Panel (1)
 9797 Left Roof Panel (2)
 7954 Roof Panel (2)
 7861 Roof Panel (2)
Step 14
ZS27
 Parts Needed For 
Roof Assembly
STEP
1
Screws To
Roof Beam
9797 Left Roof Panel
7954
Screws To
Roof Beam
Do not fasten
at this time
Strips
STEP
7861
STEP
3
7954 Roof Panel
7861 Roof Panel
FRONT
Weather Stripping Tape
Roll
2
9798 Right Roof
Panel
27