Installation Guide

1 Install three ridge caps on the
completed roof section using bolts
and nuts. Fasten roof panel over-
laps not used for ridge cap. Cover
the head of bolt with the 3" (7,6 cm)
piece of weather stripping tape. Do
not fasten the ends of the ridge caps
until instructed to do so.
2 Install the second ridge caps
overlapping the fi rst ridge caps while
installing the remaining narrow roof
panels. Cover the notched areas of
the roof panels with strips of weather
stripping tape and continue weather
stripping the ridge.
3 Fasten the lower end of the panels
to the side wall angles using screws
and washers. Use bolts and nuts
through wall angle overlaps at the
bottom of panel.
Reducing Large Gable Bulge
Loosen eight bolts and nuts shown. Ap-
ply pressure with one hand at the peak
of the gable and tighten bolt #1. Keep-
ing pressure on the gable work down
the slope tightening each bolt. Excess
material will overlap smaller gable at
seam. Once material bulge is worked
out tighten four vertical bolts that connect
the large and small gables.
 8840 Ridge Cap (3)
 7954 Roof Panel (2)
 8486 Ridge Cap (3)
Step 15
ZS28
 Parts Needed For 
Ridge Caps & Panels
STEP
1
8840
7954
8840
STEP
7954
8840
STEP
2
FRONT
28
8486
Cut
Weather Stripping
and Fold Under
8486
FRONT
8486
3
#4 # 3 # 2 # 1
1 Attach the right and left side
roof trim to the lower end of the roof
panels on each side of the building
using screws at each panel overlap.
NOTE
A single screw fastens both trim
pieces at the overlap.
2 Using your thumb and index fi nger,
overbend the bottom fl ange of the
side roof trim at the corner inward
enough so the right and left roof trim
caps fi t onto right and left corners.
3 Fasten the roof trim caps to the
side trim using a screw.
4 Fasten the roof panel ribs, peak
caps and ridge caps together using
bolts and nuts.
 8485 Left Side Roof Trim (2)
 8836 Right Side Roof Trim (2)
Step 16
D29
 Parts Needed For 
Roof Trim
STEP
1
8836
STEP
Peak Cap
Roof Trim
STEP
2
4
8485
8485
8836
Roof Trim Cap
Tuck Flange
Inward to Fit
Inside of
Roof Trim Cap
STEP
3
29