Use and Care Manual

6
Step 11: Studs
24
24R
You will need for this page:
Following dimensions, measuring from the end of angle, position a Stud Assembly inside top
angle and fasten with one (1) Stone Screw through the lower hole of angle.
1
(QTY: 16)
SS
Place bottom of Stud Assembly over Floor Frame as shown. Do not fasten bottom at this
time. Repeat procedure for the remaining Stud Assemblies around the building.
2
Assemblies from step 3:
• Stud Assemblies (12)
Inside
Outside
19 1/16”
(48,4 cm)
39 1/16” (99,2 cm)
59 1/16” (150,0 cm)
9” (22,9 cm)
49 3/8” (125,4 cm)
29 3/16” (74,1 cm)
(QTY: 2)
SS
10834
Front Wall
Channel
2
Place Front Wall Channels into poisiton behind Corner Post and Door Jamb. Fasten using
three (3) Stone Screws as shown below.
3
10834
10834
Do not fasten
at this time.
Washer