Instructions / Assembly

6
Step 16: Roof Beams/Braces
30
30P
You will need for this page:
Secure the Roof Beam Assemblies
to the Gables as shown using two (2)
Stone Bolts and Nuts on each end of
each Roof Beam Assembly.
1
Assemblies from step 4:
• Roof Beam Assemblies (3)
(QTY: 14)
SB
9204
Roof Beam
Brace
2
(QTY: 2)
SS
Attach a Roof Beam Brace to the
Main (Middle) Roof Beam and the
Gables as shown using one (1) Stone
Screw and one (1) Stone Bolt and
Nut. Repeat for other side of the Main
Roof Beam.
2
SB
SS
SB
SB
SB
SB
Locate bottom hole through tape.
Attach bottom of Roof Beam Brace to
Gables through hole.
Side of Beams with small
holes must face up.
Spread two (2)
halves of Roof
Beams
At this time, take a moment to
ensure the building is level and
square. Measure the building diagonally again to make sure the
building is square. The building should be square at the base
and at the top. This will make Roof Panels fi t better and holes will
better align.
IMPORTANT:
9204