Installation Guide

Step 2
ST15
 Parts Needed For 
Frame Assemblies
The main frame pieces reinforce
the walls. These pieces will later be
installed in the center and at the top
edge of the side walls and the rear
wall. Proceed as follows:
1 Overlap the right & left rear wall
channel pieces as shown in the  gure
and fasten the two pieces together
with 4 bolts as shown.
2 Make two side wall channels by
overlapping the right & left side wall
channel pieces as shown. Fasten
each set together with 8 bolts.
3 Overlap the rear wall angle
pieces as shown in the figure and
fasten them together with one bolt in
the center hole ( ve holes will align).
4 Make two side wall angles by
overlapping the side wall angle pieces
as shown. Fasten each set together
with one bolt thru the second large
hole from the end of each part.
5 Double check the length of each
and set these pieces aside for later
use.
 5986 Rear Wall Angle (2)
 10391 Side Wall Angle (4)
 10398 Right Side Wall Channel (2)
 10399 Left Side Wall Channel (2)
 9006 Right Rear Wall Channel (1)
 9007 Left Rear Wall Channel (1)
STEP
STEP
2
9006
10398
Side Wall Channels
157 3/8" 400,0 cm
(2 Assemblies)
STEP
4
STEP
5
Rear Wall Channel
118 1/8" 300,0 cm
3
1
9007
10399
Rear Wall Angle
118 1/8" 300,0 cm
5986
5986
10391
Side Wall Angles
157 3/8" 400,0 cm
10391
Rear Wall Angle 118 1/8" 300,0 cm
Side Wall Angles 157 3/8" 400,0 cm (2 Assemblies)
Rear Wall Channel 118 1/8" 300,0 cm
Side Wall Channels 157 3/8" 400,0 cm
(2 Assemblies)
STEP
15