Installation Guide

Step 14
 Parts Needed For 
Right Roof Panel
 7862 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner
of the building. Each screw and bolt
in the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels  t better, and holes will
align. Don't anchor the  oor frame.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to at-
taching the roof panels.
1 Locate all the roof panels by their
numbers and place them on the
ground alongside the building in their
proper positions.
STEP
2
STEP
1
FRONT
Washer
Bolt
(7)
Gable
Nut
4
1 thru 3
11 thru 13
8
5
6
7
9
10
14 thru 16
7
5
3
1
4
6
2
8
7863
7861
7861
7862
7861
7861
7861
7861
7861
7862
7861
7863
10
12
9
11
FRONT
7862 Right
Roof Panel
27
AM27
2 Position a right roof panel at the
back right corner and fasten to the
top roof beam using screws.
3 Remove edge trim from the left
gable under the roof panel.
4 Continue fastening the right
roof panel to the gable and
lower roof beams using screws,
bolts and nuts as shown. Do
not fasten the lower end of the
panels to the side wall angles
at this time.
Hint: Follow the fastener sequence
shown for proper alignment.