Instructions / Assembly

1 Position right & left corner posts
at the corners of the floor frame as
shown. The angled end of each post
must be placed on top of all four
corners. Fasten the corner post to the
floor frame with two screws.
Support the corner posts with stakes
until top frames are attached.
2 Fasten the door track assembly
(holes on top) behind the top of the
front corner posts using screws. See
the figure.
3 Fasten the rear wall angle behind
the top of the rear posts using screws.
●●
●●
● 8716 Right Corner Post (2)
●●
●●
● 8715 Left Corner Post (2)
●●
●●
● Door Track Assembly (1)
●●
●●
● Rear Wall Angle Assembly (1)
●●
●●
● Side Wall Angle Assemblies (2)
Step 6
ST19
● Parts Needed For ●
Posts/Top Frames
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this point
if you do not have enough time to com-
plete the assembly today. A partially
assembled building can be severely
damaged by light winds.
The top frame pieces give rigidity to
the side walls and provide a surface
for attaching the gables which sup-
port the roof.
4 Fasten the side wall angles be-
hind the top of the side posts using
screws. Side wall angles overlap
rear wall angle in corners.
The floor frame must be square
and level or holes will not align.
19
STEP
1
8715
STEP
3
STEP
2
STEP
4
8716
8716
8715
REAR
FRONT
SIDE
SIDE
10391
9366
Wall Angles
Must Face
Inside
Building
5986
Long Leg
On Top
Short Leg
on Bottom
Opening
Facing In
FRONT
D
oor Track Assem
bly
10391
TOP VIEW