Instructions / Assembly

Each screw in the wall requires a
washer.
1 Slide side siding (5 board) into
channels of corner and splice posts,
flat edge upward, slotted edge down
resting on floor frame. Always follow
this pattern. Fasten lower edge and
tab of stud to floor frame using screws.
Fasten center to stud with screws.
Do not fasten top edge yet.
2 Install side siding (3 board) as
before. Note how the slot in lower
edge must overlap flat edge of last
siding. Fasten both siding panels to
stud at this overlap.
3 Install side siding (5 board) to the
top as before. Remove and re-use
screw in angle to fasten top siding.
4 From inside building, fasten siding
to corner posts and splice post using
screws.
5 Install rear siding and front sid-
ing as before. Note that the front
siding is only fastened from inside.
NOTE
Be careful to install the correct
panel in each position as shown.
The floor frame must be square
and level or holes will not align.
●●
●●
● 9193 Side Siding (5 board) (8)
●●
●●
● 5305 Side Siding (3 board) (4)
●●
●●
● 8736 Rear Siding (5 board) (4)
●●
●●
● 5307 Rear Siding (3 board) (2)
●●
●●
● 8737 Front Siding (5 board) (4)
●●
●●
● 5291 Front Siding (3 board) (2)
● Parts Needed For ●
Side/Rear/Front Siding
Step 10
ST23
23
STEP
2
STEP
4
Washer
(5 board)
STEP
STEP
3
1
(5 board)
(3 board)
Front Siding Front Siding Side Siding Side Siding Rear Siding Rear Siding
(3 board) (5 board) (3 board) (5 board) (3 board) (5 board)
5291 8737 5305 9193 5307 8736
Siding Chart
(5 board)
(3 board)
(5 board)
Fasten Top
Center of Last
Siding to Stud
Fasten Siding
to Corner & Splice
Posts From Inside