Instructions / Assembly

27
Step 14
ST27
● Parts Needed For ●
Right Roof Panel
●●
●●
● 7862 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner of
the building. Each screw and bolt in
the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels fit better, and holes will
align. Don't anchor the floor frame.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1 Locate all the roof panels by their
numbers and place them on the
ground alongside the building in their
proper positions.
2 Position the right roof panel at the
back right corner and fasten to the
gable and roof beams using screws
and bolts as shown. Do not fasten
the lower end of the panels to the side
wall angles at this time.
Hint: Follow the fastener sequence
shown, for proper alignment.
STEP
2
STEP
1
FRONT
Washer
Bolt
(7)
Gable
Nut
1
8 thru 10
11 thru 13
5
2
3
4
6
7
14 thru 16
7
5
3
1
4
6
2
8
7863
7861
7861
7862
7861
7861
7861
7861
7861
7862
7861
7863
10
12
9
11
FRONT
7862 Right
Roof Panel