Instructions / Assembly

1 Install a left roof panel at the left
rear corner of the roof.
2 Install two roof panels in the se-
quence shown on previous page.
Follow fastener sequence while fas-
tening roof panels.
NOTE
Narrow roof panel rib (with bead
on it) is always overlapped by
wide rib of adjacent panel.
3 Cover the joint at the peak with
weather stripping tape (large roll).
Unroll the tape and press it down
over the opening at the ridge as you
install each roof panel. Do not cut the
tape until entire roof is completed.
4 Cut the weather stripping tape
(small roll) into 34 pieces, each piece
about 3" (8cm) long. Fold lower por-
tion of roof panels down. Press 10
pieces firmly over the notched areas
of the roof panels.
5 Install three ridge caps 6797 on
the roof section using bolts and nuts.
6 Fasten the roof panel ribs, peak
caps and ridge caps together using
bolts and nuts.
●●
●●
● 7863 Left Roof Panel (1)
●●
●●
● 7861 Roof Panel (2)
●●
●●
● 6797 Ridge Cap (3)
Step 15
ST28
● Parts Needed For ●
Roof Assembly
STEP
1
Screws To
Roof Beam
7861
Screws To
Roof Beam
STEP
7863
4
Weather Stripping Tape
28
Do not fasten
at this time
7861
6797
6797
STEP
2
STEP
6
STEP
5
STEP
3
6797