Installation Guide

Each screw in the wall requires a
washer.
1 Slide side siding (5 board) into
channels of corner and splice posts,
 at edge upward, slotted edge down
resting on  oor frame. Always fol-
low this pattern. Fasten lower edge
and tab of stud to  oor frame using
screws. Fasten center to stud with
screws. Do not fasten top edge yet.
2 Install side siding (3 board) as
before. Note how the slot in lower
edge must overlap  at edge of last
siding. Fasten both siding panels to
stud at this overlap.
3 Install side siding (5 board) to the
top as before. Remove and re-use
screw in angle to fasten top siding.
4 From inside building, fasten sid-
ing to corner posts and splice posts
using screws.
5 Install rear siding and front siding
as before. Note that the front siding
is only fastened from inside.
NOTE
Be careful to install the correct
panel in each position as shown.
The  oor frame must be square
and level or holes will not align.
22
CORRECT INCORRECT
 8735 Side Siding (5 board) (8)
 5320 Side Siding (3 board) (4)
 8736 Rear Siding (5 board) (4)
 5307 Rear Siding (3 board) (2)
 8737 Front Siding (5 board) (4)
 5291 Front Siding (3 board) (2)
 Parts Needed For 
Side/Rear/Front Siding
Step 9
M22
STEP
STEP
5
STEP
STEP
STEP
(5 board)
(3 board)
(5 board)
(5 board)
(3 board)
(5 board)
Washer
4
3
2
1