Installation Guide

1 Install three ridge caps on the
completed roof section using bolts
and nuts. Do not fasten the ends of
ridge caps until instructed to do so.
2 Fasten the remaining left and
right roof panels as you unroll the
weather stripping tape, and press it
down, install the second ridge caps
overlapping the  rst ridge caps. Align
the holes and fasten using bolts and
nuts. Cover the notched areas of
the roof panels with strips of weather
stripping tape.
3 Fasten the lower end of the panels
to the side wall angles using screws
and washers. Use bolts and nuts
through wall angle overlaps at the
bottom of panel.
 8742 Ridge Cap (6)
 7953 Left Roof Panel (1)
 7952 Right Roof Panel (1)
Step 15
M28
 Parts Needed For 
Ridge Caps & Panels
STEP
1
8742
STEP
8742
8742
8742
7953
STEP
3
7952
8742
8742
Cut
Weather Stripping
and Fold Under
2
28
1 Attach the side roof trim to the
lower end of the roof panels on each
side of the building using screws at
each panel overlap.
NOTE
A single screw fastens both trim
pieces at the overlap.
2 Using your thumb and index  nger,
overbend the bottom  ange of the side
roof trim at the corner inward enough
so the right and left roof trim caps  t
onto right and left corners.
3 Fasten the roof trim caps to the
side trim using a screw.
4 Fasten the roof panel rib, peak cap
and ridge cap together using bolts
and nuts. Fasten the remaining peak
caps in the same manner.
 8743 Side Roof Trim (4)
Step 16
M29
 Parts Needed For 
Roof Trim
STEP
1
8743
STEP
Peak Cap
Roof Trim
STEP
2
4
8743
8743
8743
Roof Trim Cap
Tuck Flange
Inward to Fit
Inside of
Roof Trim Cap
STEP
3
29