Installation Guide

ManualsBrandsArrow ManualsStorage & OrganizationWoodridge 6 ft. x 5 ft. Metal Storage Building

The door jambs reinforce the door

opening and provide an attractive

trim. The studs provide a surface for

attaching the siding panels.

1 Fasten the top of the door jambs

to the door track with 2 screws. Do

the same for the bottom into frame.

Notched edge faces toward center

of building. Fasten middle hole on

inside edge of door jamb with a bolt

inside building and a hex nut with an

acorn nut outside, as shown.

2 Place a stud between each corner

post at the sides of building and 2

studs between corner posts at the

rear. Position stud inside top angle

and fasten with a screw at the lower

hole.

3 Rest bottom tab (large hole) out-

side ﬂ oor frame. Do not fasten tab at

this time. Repeat procedure for the

remaining studs around the building.

 7311 Door Jamb (2)

 9344 Siding Stud (4)

 Parts Needed For 

Door Jambs/Studs

Step 4

BH17

1

STEP

STEP

2

NOTCHED EDGE

MUST FACE CENTER OF

BUILDING

FRONT

Bolt

3/8" (10 mm)

Hex Nut

FRONT

Washer

7311

7311

Acorn Nut

9344

9344

9344

9344

FASTEN STUD AT

LOWER HOLE

STEP

3

DO NOT FASTEN TAB

AT THIS TIME

LARGE HOLE

17