Installation Guide

Each screw in the wall requires a
washer.
1 Slide side siding into channels
of corner posts, fl at edge upward,
bottom edge down resting on fl oor
frame. Always follow this pattern.
Fasten bottom edge and tab of stud
to fl oor frame using a screw. Fasten
center to stud with screws. Do not
fasten fl at edge yet.
2 Install side siding as before.
Note how the slot in bottom edge
must overlap fl at edge of last siding.
Fasten both siding panels to stud at
this overlap.
3 Install side siding to the top as
before.
4 From inside building, fasten sid-
ing to corner posts using screws.
5 Repeat steps 1 through 4 for op-
posite side of building.
NOTE
Be careful to install the correct
panel in each position as shown.
The fl oor frame must be square
and level or holes will not align.
 9911 Side Siding (6)
 Parts Needed For 
Side Siding
Step 5
BH18
THIS SCREW MUST
FASTEN TAB OF STUD
STEP
2
STEP
3
Be certain all Siding
overlaps are fastened
with a single screw
Washer
9911
9911
End
View
Flat
Edge
Bottom
Edge
FRONT
STEP
1
STEP
4
18
CORRECT
INCORRECT