Installation Guide

Step 9
BH22
 Parts Needed For 
Right Roof Panel
 6442 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner
of the building. Each screw and bolt
in the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is
square and level. This will make
the roof panels fi t better, and
holes will align. Don't anchor
the fl oor frame.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1 Locate the roof panels by their
numbers and place them on the
ground alongside the building in their
proper positions.
2 Position the right roof panel at
the back right corner and fasten to the
gable and roof beam using screws
and bolts as shown. Do not fasten
the lower end of the panel to the side
wall angle at this time.
Hint: Follow the fastener
sequence shown, for proper
alignment.
6442 Right Roof Panel
FRONT
Washer
Bolt
Gable
STEP
2
STEP
1
Nut
1
2
3
4
5
6
7
6443
2
4
1
3
FRONT
64436442
6442
8
22