Installation Guide

ManualsBrandsArrow ManualsStorage & OrganizationWoodridge 6 ft. x 5 ft. Metal Storage Building

1 Cover the joint at the peak with

weather stripping tape. Unroll the

tape and press it down over the

opening at the ridge as you install

each roof panel. Do not cut the tape

at this time.

2 Install a left and right roof panel

in the sequence and positions shown

in Step 9. Follow fastener sequence

and instructions in Steps 9 thru 11

while fastening roof panels. Fasten

overlap at center of roof panel rib

using a bolt and nut.

NOTE

Narrow roof panel rib (with bead

on it) is always overlapped by

wide rib of adjacent panel

3 Unroll the weather stripping tape,

press it down ﬁ rmly, and cut it.

4 Fasten the lower end of the panels

to the side wall angles using screws

and washers.

Step 11

BH24

 Parts Needed For 

Front of Roof

 6443 Left Roof Panel (1)

 6442 Right Roof Panel (1)

NOTE

If roof beam holes do not line up

with the roof panel holes, shift the

building from left to right.

If this does not help, your building

may not be level. Shim the

corners until holes line up.

Cut

Weather Stripping

and Fold Under

Weather Stripping

Tape Roll

6443 Left Roof Panel

STEP

2

STEP

STEP

Fasten Overlap

at Center of

Panel Only!

1

3

STEP

4

6442 Right Roof Panel

24