Installation Guide

1 Position hinges on sides of right
and left door panels as shown and
fasten with 7/16" (11 mm) fl at head
bolts outside and #6 hex nuts inside.
2 Slide foam board into door panels,
foil facing outward, equally spaced
on both sides. See caution.
3 Cover ends of door panel with
horizontal door brace. Edge of
door panel slides into brace. Fasten
braces to doors using two screws.
4 Using an awl, ice pick or nail, push
holes through foam board at the hasp
and staple holes. Attach hasp to right
door and swivel staple to left door
using 3/4" (19 mm) fl at head bolts and
#6 hex nuts. Tighten nuts through
foam board using needle nose pliers
until they are against inside of door
panel. Cover holes in foam board
panel with a piece of foil tape.
5 Set the doors aside for later use.
Step 1
BR14
 Parts Needed For 
Door Assembly
STEP
1
9794
STEP
4
 9794 Horizontal Door Brace (4)
 9788 Right Door (1)
 9787 Left Door (1)
 67729 Foam Board (2)
Hinge
Hinge
7/16" (11 mm)
Flat Head Bolt
#6-32x3/4" (19 mm) Flat Head Bolt
END VIEW
Hasp
#6 Hex Nut
Foil Tape
67729
Hasp
9788
CAUTION:
SHARP EDGE
9794
Foil Side
STEP
2
STEP
3
Screw
#6-32x3/4" (19 mm)
Flat Head Bolt
#6 Hex Nut
Foil Tape
Swivel Staple
END VIEW
Swivel Staple
9794
Foil Side
Hinge
Screw
67729
Hinge
7/16" (11 mm)
Flat Head Bolt
9787
9794
14