Installation Guide

Step 6
BR19
 Parts Needed For 
Side/Rear Siding/Studs
 8074 Side Siding (2)
 8075 Rear Siding (1)
 8067 Siding Stud (3)
 8068 Siding Stud (2)
STEP
1 Position the side siding (6 board)
to corner posts, fl at edge of siding
upward and bottom resting on 1st side
siding. See fi gure. Always follow this
pattern. Fasten siding to corner posts
using six screws. Do not fasten fl at
edge now. Position 2nd side siding
on opposite side of building and fas-
ten as before. Always use washers
where they are shown!
2 Repeat procedure with rear siding
panel. Fasten siding to rear header
to complete rear siding.
3 Position two short siding studs
between corner posts, behind side
eave frame, and fasten tab using
a screw. Rest bottom tab of stud
between siding and fl oor frame and
fasten with a screw. Fasten siding
to studs, as shown.
4 Fasten one short siding stud to the
rear of building between the corner
posts in the same manner. Fasten
top tab behind rear header.
5 Position two long siding studs to
the left side of building in the same
manner using screws.
End View
STEP
1
Large hole in tab
8067
2
8068
8068
STEP
3
8067
8067
Bottom
Edge
Be certain all Siding
overlaps are fastened
with a single screw
8074
STEP
4
STEP
5
8075
Flat
Edge
Small hole in tab
Side Eave Frame
8074
Rear Header
19