Instructions / Assembly

19
Step 6
BR19
● Parts Needed For ●
Side/Rear Siding/Studs
●●
●●
● 8074 Side Siding (2)
●●
●●
● 8075 Rear Siding (1)
●●
●●
● 8067 Siding Stud (3)
●●
●●
● 8068 Siding Stud (2)
STEP
1 Position the side siding (6 board)
to corner posts, flat edge of siding
upward and bottom resting on 1st
side siding. See figure. Always fol-
low this pattern. Fasten siding to
corner posts using six screws. Do
not fasten flat edge now. Position
2nd side siding on opposite side of
building and fasten as before.
Al-
ways use washers where they are
shown!
2 Repeat procedure with rear sid-
ing panel. Fasten siding to rear
header to complete rear siding.
3 Position two short siding studs
between corner posts, behind side
eave frame, and fasten tab using a
screw. Rest bottom tab of stud be-
tween siding and floor frame and fas-
ten with a screw. Fasten siding to
studs, as shown.
4 Fasten one short siding stud to the
rear of building between the corner
posts in the same manner. Fasten
top tab behind rear header.
5 Position two long siding studs to
the left side of building in the same
manner using screws.
End View
STEP
1
Large hole in tab
8067
2
8068
8068
STEP
3
8067
8067
Bottom
Edge
Be certain all Siding
overlaps are fastened
with a single screw
8074
STEP
4
STEP
5
8075
Flat
Edge
Small hole in tab
Side Eave Frame
8074
Rear Header