Instructions / Assembly

ManualsBrandsArt Decor ManualsCurtain Rods & HardwareTekno 40 Traverse 48 in. Rod in Antique Silver with Elfin Finial

TEKNO 40 INSTALLATION

INSTRUCTIONS

STEP 1 - Installing Supports

Height calculation for regular clips.

Add 1” to length of drapes, plus at least 1/2” clearence from

the ﬂ oor. This measurement is the distance from ﬂ oor to center

point of Back Plate.

Please note drapes should not touch rail,

install pin on hooks with this in consideration.

M-6 BOLT COVER PLATE INSIDE POST

1. Install Back Plate to wall. Make sure all M-6 bolts are level.

If you have a spliced track the Center Support must be

installed at the position of splice.

2. Cover Back Plate with Cover Plate.

3. Screw on Inside Post very securely. Do not leave any play.

STEP 2 - Splice track if necessary

CENTER

SUPPORT

SET SCREWS

SPLICE

STEP 3 - Installing Outside Posts

1. Join the track sections

together.

2. Tighten set screws.

3. Screw Center Support

directly into center hole

of Splice.

1. Loosen all screws on Outside Posts.

2. Slide Ouside Posts into back channel of Rail.

3. Align Outside Posts with Inside Posts from Step 1.

OUTSIDE POST

2 3

1. Slide Outside Posts over

Inside Posts.

2. Once all Outside Posts

including Center Supports

are in place, tighten

posts securely by turning

clockwise.

3. Tighten set screws.

4. Finished result for

Center Supports.

5. Finished result for

side posts.

STEP 4 - Mount rail onto supports

OUTSIDE POST

CARRIERS

COVER PLATE

INSIDE POST

BACK PLATE

Summary of content (3 pages)

PAGE 1
TEKNO 40 INSTALLATION INSTRUCTIONS STEP 2 - Splice track if necessary STEP 1 - Installing Supports OUTSIDE POST 1. Join the track sections together. SPLICE CARRIERS 2. Tighten set screws. SET SCREWS COVER PLATE BACK PLATE INSIDE POST 3. Screw Center Support directly into center hole of Splice. CENTER SUPPORT Height calculation for regular clips. Add 1” to length of drapes, plus at least 1/2” clearence from the floor. This measurement is the distance from floor to center point of Back Plate.
PAGE 2
STEP 5a - Installing carriers & baton (hand draw system) 1. Slide carriers into rail. STEP 6a Installing regular carriers (corded system) 1. Remove plug next to control mechanism. 2. Attach finial onto rail. Do not overtighten as thread can strip. 2. Insert Carriers in track via slot. 3. Attach baton to side of drape you wish to operate from. Either by clipping it into first carrier or clicking into rail. 3. Re-insert plug and attach finial. Do not over-tighten as thread can strip.
PAGE 3
INSTALLATION D’UNE MISE À JOUR EURO-SCOPE KONTUR, NEXGEN, TEKNO 25, TEKNO 40 ÉTAPE 1 - Assemblage du rail lorsque le splice est inclus ÉTAPE 3 - L’installation du rail ÉTAPE 2 - Installing mounting hardware 1 2 1. Installez les embouts et insérez suite les glissière dans le rail. 2. Attachez le lance-rideau à la première glissière sur le côté desiré (ouverture à gauche ou à droite manuelle). ÉTAPE 4 - Installation du la poulie 3 4 5 6 1. 2. 3. 4.