Instructions / Assembly

STEP 6b - Cord Draw Systems, Installing Pulley
1. Attach pulley to cord. Stretch pulley until cord is tight. It is
not necessary to use excessive tension. Mark spot with pencil
on wall or fl oor. Remove cords and install pulley then
re-install cords.
• THE PULLEY MUST BE INSTALLED. IT IS THE LAW.
FAILURE TO DO SO CAN RESULT IN
INJURY TO CHILDREN OR PETS!
2. IF NEEDED - To adjust CONTROL cord drop, pull cord through
master carrier until pulley is at desired height. Pull cord an extra
few inches and knot cord at proper spot.
When you install the pulley the cord will slide back into place.
STEP 5a - Installing carriers & baton (hand draw system)
1. Slide carriers into rail.
2. Attach fi nial onto rail. Do not over-
tighten as thread can strip.
3. Attach baton to side of drape you wish to operate from.
Either by clipping it into fi rst carrier or clicking into rail.
STEP 5b -
Installing ball-bearing carriers (hand draw system)
1. Loosen set-screw holding fi nial
hanger.
do not remove screw compleatly
from fi nal hanger.
2. Slide fi nial hanger outward to
allow for ball-bearing carriers to
be inserted into rail.
Note you must retighten set-screw
to create space to insert the carriers.
3. Insert carriers
4. Loosen set-screw and push fi nal
hanger back till fl ush with rail.
Tighten set-screw permanently.
Attach fi nial. Do not over-tighten
as thread can strip.
STEP 6a -
Installing regular carriers (corded system)
1. Remove plug next to
control mechanism.
2. Insert Carriers in track via slot.
3. Re-insert plug and attach fi nial.
Do not over-tighten as
thread can strip.