Instructions / Assembly

STEP 1 - Assembling track when splicer is included

STEP 2 - Installing mounting hardware

1. Assemble Upgrade Clips for Outside Posts.

2. Attach assembled clip to Outside Posts.

3. Partially assemble Upgrade Clip for Center Post.

4. Mount Center Clip to Center Post and ﬁ nish assembly.

5. Finished result of Center Clip

6. Clips must align to be able to install track.

1 2

3 4

5 6

STEP 3 - Installing track

1. Place the front lip of the track into the front edge of the

clip. Rotate the back of the track up into the clips and snap

into place.

STEP 4 - Installing baton

1. Click-in carriers.

2. Attach baton to side or rail you wish to operate from.

Clip baton either into a carrier or directly into the rail.

STEP 5 - Installing Pulley

1. Determine if cord is on the side you wish to operate.

Control side can be changed by pulling cord through

opposite control.

2. Attach cord to pulley. Stretch pulley and create sufﬁ cient

tension so cord remains in track. Do not apply excessive

tension. Mark spot with pencil on wall or ﬂ oor.

3. Remove cords and fasten pulley to wall or ﬂ oor.

Re-install cords.

• THE PULLEY MUST BE INSTALLED. IT IS THE LAW.

FAILURE TO DO SO CAN RESULT IN

INJURY TO CHILDREN OR PETS.

4. For center opening tracks greater than 84”, click in

plastic plug at center point of rail to help support cords.

PLUG

INSTALLATION OF EURO-SCOPE UPGRADE

KONTUR, NEXGEN, TEKNO 25, TEKNO 40