Instructions / Assembly

STEP 6 - Cord Draw Systems, Installing Pulley

1. Attach pulley to cord. Stretch pulley until cord is tight. It is

not necessary to use excessive tension. Mark spot with pencil

on wall or ﬂ oor. Remove cords and install pulley then

re-install cords.

• THE PULLEY MUST BE INSTALLED. IT IS THE LAW.

FAILURE TO DO SO CAN RESULT IN

INJURY TO CHILDREN OR PETS!

2. IF NEEDED - To adjust CONTROL cord drop, pull cord through

master carrier until pulley is at desired height. Pull cord an extra

few inches and knot cord at proper spot.

When you install the pulley the cord will slide back into place.

STEP 5a - Installing carriers & baton (hand draw system)

1. Remove end cap from rail.

2. Slide Carriers into rail.

3. Re-install end cap

4. Attach baton to side of drape you wish to operate from.

Either by clipping it into ﬁ rst carrier or clicking into rail.

STEP 5b - Installing regular carriers (corded system)

1. Remove plug next to

control mechanism.

2. Insert Carriers in track via slot.

3. Re-insert plug.

STEP 5c - Installing ball-bearing carriers (corded system)

1. In some cases the ball bearing carriers have been installed.

2. To add or subtract carrieres slid the RETURN cap off rail

(do not compleatly remove - let the cap stay inside of rail)

and insert carriers within the gap provided.

3. Re-insert RETURN cap.

RETURN END

CONTROL END