Instructions / Assembly

ManualsBrandsArt Decor ManualsCurtain HardwareNexgen/T25 Upgrade to 4 in. - 96 in. Support Kit in Distressed Wood

NEXGEN INSTALLATION

INSTRUCTIONS

STEP 1 - Installing Supports

OUTSIDE POST

CARRIERS

COVER PLATE

INSIDE POST

BACK PLATE

Height calculation

This will depend on the way the drape is placed. Distance from

center point of Back Plate to top of the rail is 1/2”.

M-6 BOLT COVER PLATE INSIDE POST

1. Install Back Plate to wall. Make sure all M-6 bolts are level.

If you have a spliced track the Center Support must be

installed at the position of splice.

2. Cover Back Plate with Cover Plate.

3. Screw on Inside Post very securely. Do not leave any play.

STEP 2 - Splice track if necessary

CENTER

SUPPORT

SET SCREWS

SPLICE

STEP 3 - Installing Outside Posts

1. Join the track sections

together.

2. Tighten set screws.

3. Screw Center Support

directly into center hole

of Splice.

1. Loosen all screws on Outside Posts.

2. Slide Ouside Posts into back channel of Rail.

3. Align Outside Posts with Inside Posts from Step 1.

OUTSIDE POST

2 3

1. Slide Outside Posts over

Inside Posts.

2. Once all Outside Posts

including Center Supports

are in place, tighten

posts securely by turning

clockwise.

3. Tighten set screws.

4. Finished result for

Center Supports.

5. Finished result for

side posts.

STEP 4 - Mount rail onto supports

Summary of content (3 pages)

PAGE 1
NEXGEN INSTALLATION INSTRUCTIONS STEP 1 - Installing Supports STEP 2 - Splice track if necessary 1. Join the track sections together. SPLICE OUTSIDE POST 2. Tighten set screws. SET SCREWS CARRIERS COVER PLATE BACK PLATE 3. Screw Center Support directly into center hole of Splice. INSIDE POST CENTER SUPPORT Height calculation This will depend on the way the drape is placed. Distance from center point of Back Plate to top of the rail is 1/2”.
PAGE 2
STEP 5a - Installing carriers & baton (hand draw system) 1. Remove end cap from rail. 2. Slide Carriers into rail. 3. Re-install end cap 4. Attach baton to side of drape you wish to operate from. Either by clipping it into ﬁrst carrier or clicking into rail. STEP 5b - Installing regular carriers (corded system) 1. Remove plug next to control mechanism. 2. Insert Carriers in track via slot. 3. Re-insert plug. STEP 5c - Installing ball-bearing carriers (corded system) 1.
PAGE 3
INSTALLATION OF EURO-SCOPE UPGRADE KONTUR, NEXGEN, TEKNO 25, TEKNO 40 STEP 1 - Assembling track when splicer is included STEP 3 - Installing track STEP 2 - Installing mounting hardware 1. Place the front lip of the track into the front edge of the clip. Rotate the back of the track up into the clips and snap into place. STEP 4 - Installing baton 1 2 1. Click-in carriers. 2. Attach baton to side or rail you wish to operate from. Clip baton either into a carrier or directly into the rail.