Specifications

15
www.blitzrcworks.com
If this radio system is being used on a nitro gas powered aircraft, please connect the throttle into
another channel first and then plug it into BATT channel on the receiver after binding.
4. Unplug the bind plug and there will be
a flashing light.
2. Press the bind button on the back of
your transmitter and then turn on the
transmitter
3. A light will be visible to indicate that the
bind process is complete and was successful.
BINDING YOUR 2.4GHZ RADIO SYSTEM
1. Plug in the short-circuit plug (bind plug
as shown with a small looped wire at the
end) into the BATT channel on the receiver.
Connect the ESC to the receiver for
electricity to be sent to the motor.
5. Press bind button up into “work mode.”