Specifications

TRANSMITTER FUNCTIONS

The ETC63- 2.4GHz is a newly developed 6 channel proportional transmitter and is the latest

development of Art-Tech RC Hobby Corporation. This radio system uses digital frequency hopping

technology and has an enormous advantage in comparison to the traditional radio systems. The ETC63-

2.4GHz Radio System does not use crystals, prevents frequency interference, uses a short antenna, and

has low energy consumption.

FEATURES:

1. Flight time display of seconds and minutes.

2.Voltage display- includes a low voltage alarm. A red LED flash is visible when battery voltage is lower

than 8.5V.

3.Channel output reverse set.

4. Up to 5 types of aircraft modes to choose from; contains 12 independent aircraft data storage and call.

5.Mode 1 and Mode 2 available.

6.Throttle protection to avoid danger of motors starting suddenly when

throttle hold switch is turned on. The throttle output value will be set to

the minimum. When restarting the transmitter for any reason and the

throttle output value is not set to the minimum, the red LED flashes an alarm as shown in the figure. The

throttle will automatically set to the minimum value setting and the transmitter will lock. When the

transmitter is adjusted properly, the transmitter will unlock itself.

7.Channels 1, 2, and 4 uses DR (Dual Rate) and EXP (Exponential Curve) settings.

8.All channels operate on EPA (end of the process) setting.

9.Channel 5 operates on a two-state setting includes gyroscope sensitivity setting for helicopters and

landing gear set up for fixed-wing airplanes.

10.Channels 3 and 6 using general and 3D mode curve setting for general and CCPM helicopters

11.Four groups of channel mixing controls

12.All channel output dynamic display

13.All channel midpoint regulation

14.Ability to restore to factory settings

15.Channels 1 through 6 auxiliary fine-tune settings

Thank you for purchasing the ETC63- 2.4GHz Radio Control system. For safety

precautions, you must read this manual before operating. BlitzRCWorks and the retailer

are not responsible for any damage or loss resulted from improper usage and mishandling,

as this will be the sole responsibility of the user.