Specifications

04
Specifications
Number of channels: 6
Charging Jack: Included
3D Switch: Included
Power Supply: 12V (1.5V, 8 AA Batteries)
Voltage Display: LCD
The spare parts below is only offered in a complete set:
1. Transmitter: ETC63-2.4GHz
2. Receiver: ER62-2.4GHz
3.Manual
ITEMS INCLUDED
Color: Black
Antenna Length: 15cm
Can be used on: Airplanes, and Helicopters
Certification: FCC, CE, RoHS
SAFETY WARNINGS
www.blitzrcworks.com
3 AS-100 9g Servos
Simulator Cable
Belt
9.6V Ni-MH Battery
Charger
CD Rom
CLIMATE CONTROL: Do not operate your aircraft in the rain or in the
presence of a strong wind. Water can damage the transmitter and may
cause your aircraft to lose control. This can cause a crash and even
lead to serious injuries.
BIND BUTTON: Make sure the frequency bind button is up and not
pressed down. The radio system may need to rebind again. You can
find the information on binding your radio system in this manual.
BINDING: Only bind one radio system at a time. Do not try to bind
more than one receiver to a transmitter or more than one transmitter
to a receiver. Make sure you turn off your other RC devices while
binding.
PREFLIGHT TEST: Always perform a mandatory preflight test by
testing all of your controls before flight. You may need to adjust your
settings to ensure a good flight. A range test is also a must before
flight. You can do so by testing the controls of your aircraft with your
transmitter at a close distance and then slowly walk further
away. A few hundred feet would be a good distance to test.
APPROPRIATE LOCATIONS: DO NOT fly near houses,
at an airport, near any power lines or on the street and
roads. You may be fined and can also caused damages
to your surroundings and injuries. Please also do not fly
in a crowded area.