Specifications

MENU INTRODUCTION

After turning on the radio, the screen displays the time page. Press menu

several times to enter into the main menu. Press the sub button at this time to

enter into the sub menu.

There will be a single beep sound to indicate a button pressed. If you do not

hear any sound after pressing a button, check if the button is in place. It may

be that the button you have pressed is not applicable in this menu so try

pressing another button to hear for any sounds.

When the special function button (Y/UP or N/DOWN) is pressed, there will be

3 beeping sounds in descending pitches. When the menu setting is complete,

press the menu button or sub button for a couple of seconds to hear the 2

beeping sounds then release the button to return to the time page.

1. Press the menu button and then enter into the data storage menu (mode select).

2. Press the right button and then Y/UP button to confirm. As shown in the figure

on the right, the top left of the display area shows the abbreviation of the selected

mode 1. Yes means that the chosen mode is set at “A”.

1.2 Storing data for different models:

1. Press the sub button to enter into the mode menu (the save function).

2. Press the left or right button to choose a storage location.

3. Press Y/UP button to confirm storage. You can store up to a total of 12 models.

1.3 Selecting the stored mode:

1. Press the sub button to enter into the data call menu (the load function).

2. Press the left of right button to choose a stored model.

3. Press Y/UP button to confirm data.

“Load” means that the data value is being set now. “Non” means that there

has been no data stored in this location. As shown in the figure on the right, H

means the stored information is in a helicopter mode. “R” means Model 1 and

“L” means Mode 2.

1.1 Flying mode settings:

1.MODE SELECTION

2.SERVO REVERSE SETTINGS

Servo reversing is where the control input of that servo is running opposite of

the desired direction. For instance, if one of your aileron servo is moving up

when you are commanding it to go down, and it is going down when you are

trying to position it up, then you can reverse the servo through your

transmitter.

1. Press the menu button to enter into the Rev menu (servo reversing).

2. Press the left or right button to choose a channel.

3. Press Y/UP button to change the reversing setting.