Dual Reamping Direct Box Artcessories User's Manual
IMPORTANT SAFETY INSTRUCTION – READ FIRST This symbol, whenever it appears, alerts you to the presence of uninsulated dangerous voltage inside enclosure-voltage that may be sufficient to constitute risk of shock. This symbol, whenever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. Please read the manual. Read Instructions: Retain safety and operating instructions for future reference. Heed all warnings printed here and on the equipment.
Installation: Install the unit in accordance with the instructions printed in the user guide. INTRODUCTION: Thanks for purchasing Applied Research and Technology’s Dual RDB. The Dual RDB is the ideal input solution for any application where stereo or dual Line level signals from Mixers, Recording interfaces, iPods, Laptop computers, consumer DVD players, Consumer HiFi equipment or video machines have to be connected to XLR microphone or 1/4" instrument level inputs.
FEATURES: • • • • • • • • • Transformer isolated XLR microphone level outputs Transformer isolated 1/4" TRS instrument level outputs 20 to 20,000Hz Frequency Response Dual XLR line level inputs Dual 1/4-inch TRS line level inputs Variable Level Controls that can fully mute.
INSTALLATION and OPERATION: Connect your line level signal to INPUT 1 - 1/4" TRS phone jacks or XLR Input connector. Connect either 1/4" jack or XLR of OUTPUT 1 to an instrument or mic input. For dual operation, connect INPUT 2 and OUTPUT 2 in a similar manner and set the OUTPUT 2 SOURCE switch to Input 2.If you want to split INPUT 1 into two outputs, set the OUTPUT 2 SOURCE switch to Input 1. Use the OUTPUT 2 PHASE switch to correct phase error problems elsewhere in the audio system.
Signal Flow Chart
APPLICATIONS: • • • • Re-amping interface for multiple amps Stereo/Dual direct box Variable input pad for mic or instrument inputs Stereo Audio/Video interface to low level inputs
SPECIFICATIONS: Frequency Response: 20 Hz - 20 kHz, ± 0.5 dB @ +4 dBu THD: .01% @ 1kHz, +18 dBu <.05% @ 100Hz, +18dBu Channel Separation: > 80 dB (typical) Input Connections: 1/4" TRS balanced, XLR balanced female Output Connections: 1/4" TRS balanced, XLR balanced female Insertion loss: -20dB @100k Ohm load, -25dB @600 Ohm load Dimensions HxWxD (in): 1.85 x 4.6 x 3.9 HxWxD(mm): 47 x 117 x 99 Weight (lbs/kg) : 0.88 / 0.
WARRANTY INFORMATION: Limited Warranty (USA only) Applied Research and Technology will provide warranty and service for this unit in accordance with the following warrants: Applied Research and Technology, (ART) warrants to the original purchaser that this product and the components thereof will be free from defects in workmanship and materials for a period of three years from the date of purchase.
or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific rights and you may have other rights, which vary, from state to state. The warranty terms listed above are only valid within the United States of America. For units purchased outside the United States, an authorized distributor of Applied Research and Technology will provide service. For information on warranty and service policies outside of the U.S., please contact your local distributor.
SERVICE: The following information is provided in the unlikely event that your unit requires service. 1. Be sure that the unit is the cause of the problem. Check to make sure that the unit has power supplied, that all cables are connected correctly, and that the cables themselves are in working condition. You may want to consult with your dealer for assistance in troubleshooting or testing your particular configuration. 2. If you believe that the ART unit is at fault, go to www.artproaudio.com.
www.artproaudio.com E-mail: support@artproaudio.
RDB-5004-101 V1.
