User`s guide

Section - 3 Editing Programs
Selecting A Program
When you first turn on your 2120 VGS, it boots up in Program mode and the display will appear something like this:
To select a Program, do the following:
1. Make sure Program mode is selected (the <Program> button will be brightly lit). If the <Program> button is dim, press it
once to return to Program mode.
2. Use the <Program> button to select the Program bank (Factory or User). Each successive press of the <Program> button
toggles between the Factory and User bank of programs.
3. Using the <Program/Effect> wheel, scroll to the program you want to hear.
Selecting Effect Configurations
The 2120 VGS gives you the ability to select any one of the twenty-four different effect routing configurations within the selected program. The
procedure to do so is as follows:
1. From Program mode, press the <Other> button. The display appears something like this:
2. Notice that the entire digital effects screen is flashing. At this point turn the <1> knob under the display to select any one of the
twenty-four different effect routing configurations available in the 2120 VGS. Once you have the desired Effect configuration
selected, you can load the effect modules you need for your particular program needs. press the <Store> button to save any
changes. Pressing the <Program> button will return you to Program mode.
Config:1 SDISC 2,2
2
USER
2
1
CHANGEDLINK

2
CHANGEDLINK
3
CHANGEDLINK CHANGEDLINK
PAGE
1
OF 2
COMP WAH TUBE EQ
L/R OUTS
CLIP
#
b
GATE
SEAMLESS


Satch 2
2
USER
%kHz
msdB
0
1
CHANGEDLINK
%kHz
msdB
0
2
CHANGEDLINK
%kHz
msdB
0
3
CHANGEDLINK
%
100
4
CHANGEDLINK
PAGE OF 11
COMP WAH TUBE EQ
L/R OUTS
CLIP
#
b
GATE
SEAMLESS


2120 VGS Artist
User Guide
Section - 3 Editing Programs
19