User`s guide

to 100%.
Balance This parameter allows you to pan the Dry signal either to the Right or the Left in the stereo soundfield. Ranges
from Left 99 to Right 99.
Min Shift This parameter sets the minimum pedal shift level of the Whammy effect. Ranges from: -72 (6 octaves down), to
24 (2 octaves up).
Max Shift This parameter set the maximum pedal shift level of the Whammy effect. Ranges from: -72 (6 octaves down), to
24 (2 octaves up).
Min Detune This parameter sets the minimum pedal level of detune effect. Ranges from: -50% (down 50 cents), to 50% (up
50 cents).
Max Detune This parameter sets the maximum pedal level of detune effect. Ranges from: -50% (down 50 cents), to 50% (up
50 cents).
Pedal This parameter is used for the assignment of an expression pedal. This parameter also shows the pedal travel
range. Ranges from: 0 to 100
Out This parameter is used to set the overall output level of the Whammy module. Ranges from: 0 to 100%
Pan This parameter is used for for the position of the Whammy effect in the Stereo soundfield. Ranges from: Left
99 to Right 99.
Auto Wah
The Auto Wah is a great effect use when you want nasally wah-type effect but you don’t want to do the leg work. The Auto Wah utilizes a
sensitivity detector that reads the input signal, then simulates the action of a wah pedal.
Auto Wah Effect Parameters:
Auto Wah On/Off Turns the Auto Wah module on or off. When the module is turned off, the signal will continue to pass through
the module.
FX Level This parameter lets you select the overall FX level mix of the Auto Wah Effect module. Ranges from: Off to
100%.
Sensitivity This parameter adjusts the sensitivity of the detection of the automatic wah. The higher the sensitivity is set, the
wider the Wah range is. Ranges from: Off to 100%.
2120 VGS Artist
User Guide
Section - 4 Effects and Parameters
47